Ciencias Exactas y Ciencias de la Salud

Permanent URI for this collectionhttps://hdl.handle.net/11285/551039

Pertenecen a esta colección Tesis y Trabajos de grado de las Maestrías correspondientes a las Escuelas de Ingeniería y Ciencias así como a Medicina y Ciencias de la Salud.

Browse

Advisor: search.filters.advisor.Elías Zúñiga, AlexSubject: search.filters.subject.Selective Laser Melting

Search Results

Now showing 1 - 1 of 1
  • Thumbnail Image
    Tesis de maestría
    Dimensional analysis for tuning Selective Laser Melting parameters for near-full density of Inconel 718
    (Instituto Tecnológico y de Estudios Superiores de Monterrey, 2020-06) Estrada Díaz, Jorge Alfredo; ELIAS ZUÑIGA, ALEX; 19150; Elías Zúñiga, Alex; ilquio, emipsanchez; Martínez Romero, Oscar; Olvera Trejo, Daniel; School of Engineering and Sciences; Campus Monterrey; Rodríguez Salinas, Juan José
    Selective laser melting is a powder bed fusion process that allows the production of metallic pieces of high geometrical complexity. Full densification is regarded as fundamental to achieve mechanical integrity. Nevertheless, doing so for a new material requires an intensive, in time and resources, experimentation stage in order to set proper manufacturing parameters. In this work, dimensional analysis is used to develop a general mathematical model on bulk density of SLMed components taking volumetric energy density, scanning speed and powder’s thermal conductivity, specific heat capacity and average grain diameter as independent variables. Strong relation between dependent and independent dimensionless products was observed. Bulk density is found to be proportional to volumetric energy density and be affected by scanning speed by a factor of negative two. Inconel 718 probes were produced and a particular expression, in the form of a first order polynomial, for its bulk density,in the independent dimensionless product π1 range from 3.17x10−8 to 4.6 x10−8 was obtained. In this range, better densification is achieved at lower scanning speed and lower laser power. The first is related to higher exposure time and ensuring full melt of the powder, and the second may be due to powder particle sublimation / ejection due to improperly large laser power conditions. An average relative density of 95.218% was measured. An average error percentage of 1.6503% between experimental and predicted bulk density (and dimensionless density) was achieved. A mathematical tool for tuning scanning speed to achieve full densification, with respect to laser power, was developed. Moreover, particular conditions for achieving so for Inconel 718 in the π1 range was provided.
En caso de no especificar algo distinto, estos materiales son compartidos bajo los siguientes términos: Atribución-No comercial-No derivadas CC BY-NC-ND http://www.creativecommons.mx/#licencias
logo

El usuario tiene la obligación de utilizar los servicios y contenidos proporcionados por la Universidad, en particular, los impresos y recursos electrónicos, de conformidad con la legislación vigente y los principios de buena fe y en general usos aceptados, sin contravenir con su realización el orden público, especialmente, en el caso en que, para el adecuado desempeño de su actividad, necesita reproducir, distribuir, comunicar y/o poner a disposición, fragmentos de obras impresas o susceptibles de estar en formato analógico o digital, ya sea en soporte papel o electrónico. Ley 23/2006, de 7 de julio, por la que se modifica el texto revisado de la Ley de Propiedad Intelectual, aprobado

DSpace software copyright © 2002-2025

Licencia