2018-10-182018-10-182212827110.1016/j.procir.2015.11.020http://hdl.handle.net/11285/630393The design of coronary stents imposes high demands in terms of dimensional tolerance and surface finish. These devices are manufactured by laser microcutting of miniature tubes in materials such as stainless steel, cobalt chromium alloys and Nitinol. The work presented here is focused on fiber laser microcutting for coronary struts in AISI 316L stainless steel. This work studies the influence of gases such compressed air and argon passing through the tube in order to drag molten material while laser microcutting is performed. The experimental work studies the influence of beam spot overlap and pulse energy on back wall dross and average surface roughness, using response surface methodology. The results indicate that the introduction of compressed air or argon gas is a relevant method to reduce the amount of dross adhered in the back wall of the miniature tube. © 2016 The Author(s).info:eu-repo/semantics/openAccesshttp://creativecommons.org/licenses/by-nc-nd/4.0Alloy steelArgonArgon lasersChromium alloysCompressed airFiber lasersMolten materialsPressure vesselsSteel fibersSurface roughnessTubular steel structuresAISI316L stainless steelAverage surface roughnessback wall drossCobalt-chromium alloysLaser micro-cuttingPulse energiesResponse surface methodologySpot overlapStainless steel7 INGENIERÍA Y TECNOLOGÍAConferencia49222226